Everything2Stroke Forum banner

Port map analyser software...

Jump to Latest Follow

1 - 2 of 2 Posts
M

·
Registered
Joined
·
25 Posts
Discussion Starter • #1 •
Hi all, has anyone purchased the software from http://www.porting-programs.com? I did in 2012, there have been no updates since then, but my download links in the email no longer exist. I've tried emailing 3 addresses attached to the site but a week later am yet to get a response. If anyone has the software could you please contact me? I have proof of transaction etc to appease the mods. Even better would be if anyone knows how to contact the developer...

Thank you
 
Morph0906

·
Super Moderator
Joined
·
6,688 Posts
#2 •
sheesh man good luck if you get a response please let us know...
 
1 - 2 of 2 Posts
Recommended Reading
Read More

  1. No Start When Hot

    In depth Tech
    I picked this vintage 2-stroke up recently with less than 500 miles that had been sitting dormant in a garage for almost 50 years. I cleaned the carb and tank and put in a new battery and it started up and ran fine. Then I proceeded with the full restoration including a new coil and plug and...

  2. About Carb Jetting

    In depth Tech
    What I’ve Learned Different About Carb Jetting 1. the main jet affects the idle mixture because some fuel is pulled up past the space between the needle shaft and the needle jet, and the main jet although its flow area is bigger, still does affect the flow past the needle at that setting. 2...

  3. Advice re damaged lower case half - Suzuki T350

    In depth Tech
    Greetings, I have a small shop near Asheville, NC specializing in vintage Japanese motorcycles. I have much more experience with the vintage four-stroke engines than the two-strokes and will be grateful for the collective knowledge and experience of this group. My immediate question is...

  5. issues with my 1975 yamaha rs125

    In depth Tech
    hello everyone i am have issues with my 1975 yamaha rs 125. I found the bike stored in a friends rental accommodation a while back and chatted to the previous tennants about it. It had been standing in the same spot for approx. 15years untouched and very unloved. This didn't sit rightly with...

  6. Acellerated piston ring wear

    In depth Tech
    Hello everyone I'm looking for opinions on my ring wear, I seem to be going through rings too quickly and can't nail down the root cause. I'll start with the bike... 2007 Honda CR250 that I ride mostly in tight and steep single track / x-country riding. Engine is leak-free and gets pressure...
Read More
About this Discussion
1 Reply
2 Participants
Last post:
Morph0906
Everything2Stroke Forum
A forum community dedicated to all 2 stroke engine vehicle owners and enthusiasts. Come join the discussion about your favorite engine’s performance, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Suzuki LT250 Yamaha Blaster Honda TRX 250R In depth Tech Suzuki LT500
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Top