Joined
·
1,095 Posts
Since many of us run Mikuni's >>Mikuni Carb Tuning Manual , I'll pin this up as well. :thumbsup:
Mikuni Carb Tuning Manual
1 - 3 of 3 Posts
Joined
·
984 Posts
good info right there..
Joined
·
3 Posts
Radius rods are customarily made of stamped steel or aluminum for lightness, as they are part of the vehicle's unsprung weight. Improvements in composite materials technology make possible plastic suspension links, although they are still uncommon.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
No Start When Hot
In depth TechI picked this vintage 2-stroke up recently with less than 500 miles that had been sitting dormant in a garage for almost 50 years. I cleaned the carb and tank and put in a new battery and it started up and ran fine. Then I proceeded with the full restoration including a new coil and plug and...- 0
- 50
-
About Carb Jetting
In depth TechWhat I’ve Learned Different About Carb Jetting 1. the main jet affects the idle mixture because some fuel is pulled up past the space between the needle shaft and the needle jet, and the main jet although its flow area is bigger, still does affect the flow past the needle at that setting. 2...- 0
- 218
-
Advice re damaged lower case half - Suzuki T350
In depth TechGreetings, I have a small shop near Asheville, NC specializing in vintage Japanese motorcycles. I have much more experience with the vintage four-stroke engines than the two-strokes and will be grateful for the collective knowledge and experience of this group. My immediate question is...- 1
- 462
-
issues with my 1975 yamaha rs125
In depth Techhello everyone i am have issues with my 1975 yamaha rs 125. I found the bike stored in a friends rental accommodation a while back and chatted to the previous tennants about it. It had been standing in the same spot for approx. 15years untouched and very unloved. This didn't sit rightly with...- 3
- 2K
-
Acellerated piston ring wear
In depth TechHello everyone I'm looking for opinions on my ring wear, I seem to be going through rings too quickly and can't nail down the root cause. I'll start with the bike... 2007 Honda CR250 that I ride mostly in tight and steep single track / x-country riding. Engine is leak-free and gets pressure...- 33
- 9K
-
dANbOT · updated
Join now to ask and comment!