Everything2Stroke Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I’m stumped. I recently replaced the cylinder and piston on my ole reliable ‘06 husqvarna and now it won’t start. I’ve checked for kill switch shorts, Coil-flywheel gap, carb is new, compression is good. I put a tiny bit of 2 stroke oil in the cylinder and forgot to take the plug out so maybe the oil fouled it out when I pulled on it? I’m not sure but I doubt it. I’m not ready to retire it just yet
 

·
Registered
Joined
·
6 Posts
I’m stumped. I recently replaced the cylinder and piston on my ole reliable ‘06 husqvarna and now it won’t start. I’ve checked for kill switch shorts, Coil-flywheel gap, carb is new, compression is good. I put a tiny bit of 2 stroke oil in the cylinder and forgot to take the plug out so maybe the oil fouled it out when I pulled on it? I’m not sure but I doubt it. I’m not ready to retire it just yet
Check the spark plug. If you put that oil in it that could’ve fouled the plug. Also sounds like you may need to adjust your new carb.
 
1 - 2 of 2 Posts
Top