Everything2Stroke Forum banner
3K views 7 replies 4 participants last post by  Slider 
#1 ·
hi again guys , i am tryin to change crank seals in a 82 rm 125 the fly wheel side is no problem,the problem is the clutch side can anyone tell me what i do or do,nt have to remove to get at seal! i see what looks like a nut and some gears on shaft but do,es the i think it is called the water pump shaft and gear have to come off too???? any tips or advise would be a great help i have never change them before thanks
 
#2 ·
clutch side crank seal

hi guys can anyone tell me how to change crank seal on clutch side on a 1982 rm 125???? stator side was no problem just not sure how to go about do,in the other side. any tips or info on how to do it would be great thanks..
 
#5 ·
#8 ·
1) Drain coolant
2) Remove Kick starter and lower brake pedal (you can lay the bike on its left side so you don't have to drain the gear oil)
3) Remove right side cover
4) Remove the entire clutch basket
5) Remove pto gear
6) Remove seal

7) reassemble
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top