Everything2Stroke Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter · #1 · (Edited)
ok. like before, its leaking anti freeze into the oil, i put a new water pump shaft, seal, bearings and cleaned the carb,in it after the first inncidence with it, i put it all togeather fire it up, and i pulled the check oil bolt out and after a couple of seconds of running my oil started to turn milky again, so any ideas on any of the two problems would probly help out alot cause im lost as of now. thanks
 

·
Old School but still Cool
Joined
·
2,844 Posts


Look carefully at your right engine cover..(on the image look at no.11).....the gasket is not sealing where the coolant flows through the case to the cylinder. You need to replace the gasket and get some Yamabond or Hondabond HT sealant and apply it to where the case cover meets the case. That is where your coolant is leaking into the clutch area and thus into your gearbox.

This is something I have to do to my Suzuki when I replace the right crankshaft seal.
 
1 - 2 of 2 Posts
Top