Everything2Stroke Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
New to the forum and so I just bought a blaster about a month ago and it was a non running blaster. Pull started if and it started up. Never was able to kick start but it'd start and run when pulled. And it'd kick start after warm up. So I rebuilt the carb thinking that might've been the problem but once I did it didn't want to run at all. It had a 250 main stock pilot and the needle clip set in the second notch. When I rebuilt it I put it as stock but slowly started changing it back to the old setting and old stuff. Now everything besides the float needle and float valve are stock in it and it runs but dies right after it's warmed up. Can't figure it out. It has a dg header. Stock silencer. Air box lid off. That's as much as I know about it. Any help would be appreciated.
 
1 - 1 of 1 Posts
Top