Roll Design Steering Stem

Steering stems are often over looked as an upgrade to an ATV. My biggest reason for wanting an aftermarket steering stem was because of my height. I'm 6'3" so riding while standing gets to be a huge strain on my back. With the added height it allows me to ride in a better position standing. Another reason was I wanted to move to a FatBar from Renthal which requires larger Handle bar Clamps. For this I got the IMS handle bar clamps for the 1 1/8" bars. These also incorporate a rubber bushing to damper the bumps.

Overall the complete system Roll Design Stem and IMS Clamp eliminated a lot of the handle bar bumps and shakes. This eliminated rider fatigue and allowed for a more pleasurable day of riding. The strength difference between stock and aftermarket is huge. Rolling an ATV is very common and just something that comes with riding. To not have to worry about your stem snapping the top off or bending is a good insurance.

One thing to consider when buying an extended stem is cable length. I found that my throttle cable was fine but I have aftermarket brake lines that are already extended for my A-Arms so I did not see a need for any more length. My clutch cable is still stock and did not have any issues with it. Installation of a stem is pretty straightforward.

First you're going to want to remove the front plastics. Then this will give you better access to everything that you will need to get at. The next thing you will need to move out of the way is the radiator. Notice I said move out of the way, you should have plenty of room once the radiator is moved forward this will save you time from not having to drain the radiator. Then you should detach the tie-rods and detach the upper collar. Be careful with the collar because there are seals in there that you don't want to lose. Last part that is attached is the very bottom of the stem just remove the nut and washer and your stock stem is out. Now your ready to repeat the steps to put the new stem in.

If you do decide on getting an aftermarket Stem I think you will be happy with your purchase. If you are thinking of getting a steering stabilizer don't waste your time or money get a stem first and see what you think.